linux user group brescia

Il mar, 2002-06-04 alle 23:15, andrea gelmini ha scritto:
> posta il risultato di dmesg

Tutto? Eccolo!

Linux version 2.4.18-6mdk (quintela a bi.mandrakesoft.com) (gcc version 2.96 20000731 (Mandrake Linux 8.2 2.96-0.76mdk)) #1 Fri Mar 15 02:59:08 CET 2002
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000e1bd8 - 00000000000ec028 (reserved)
 BIOS-e820: 00000000000f7ccb - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 000000000c000000 (usable)
 BIOS-e820: 00000000fec00000 - 00000000fed00000 (reserved)
 BIOS-e820: 00000000fee00000 - 00000000fef00000 (reserved)
 BIOS-e820: 00000000ffff7ccb - 0000000100000000 (reserved)
On node 0 totalpages: 49152
zone(0): 4096 pages.
zone(1): 45056 pages.
zone(2): 0 pages.
Kernel command line: BOOT_IMAGE=linux ro root=301 quiet devfs=mount
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
Initializing CPU#0
Detected 347.669 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 693.04 BogoMIPS
Memory: 190936k/196608k available (1170k kernel code, 5284k reserved, 332k data, 260k init, 0k highmem)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0183fbff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 512K
CPU: After vendor init, caps: 0183fbff 00000000 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU:     After generic, caps: 0183fbff 00000000 00000000 00000000
CPU:             Common caps: 0183fbff 00000000 00000000 00000000
CPU: Intel Pentium II (Deschutes) stepping 02
Enabling fast FPU save and restore... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch a atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfd933, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router PIIX [8086/7110] at 00:07.0
Limiting direct PCI/PCI transfers.
isapnp: Scanning for PnP cards...
isapnp: Card 'CS4235'
isapnp: 1 Plug & Play card detected total
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
Starting kswapd
VFS: Diskquotas version dquot_6.5.0 initialized
devfs: v1.10 (20020120) Richard Gooch (rgooch a atnf.csiro.au)
devfs: boot_options: 0x1
vesafb: framebuffer at 0xf7000000, mapped to 0xcc800000, size 4096k
vesafb: mode is 800x600x16, linelength=1600, pages=3
vesafb: protected mode interface info at c000:4781
vesafb: scrolling: redraw
vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0
Looking for splash picture.... found (800x600, 53754 bytes).
Console: switching to colour frame buffer device 80x16
fb0: VESA VGA frame buffer device
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with HUB-6 MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
block: 128 slots per queue, batch=32
RAMDISK driver initialized: 16 RAM disks of 32000K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xfcb0-0xfcb7, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xfcb8-0xfcbf, BIOS settings: hdc:DMA, hdd:pio
hda: SAMSUNG SV0432A 010, ATA DISK drive
hdc: ATAPI CD-ROM DRIVE 24X MAXIMUM, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 8421840 sectors (4312 MB) w/482KiB Cache, CHS=524/255/63, UDMA(33)
hdc: ATAPI 20X CD-ROM drive, 120kB Cache, DMA
Uniform CD-ROM driver Revision: 3.12
Partition check:
 /dev/ide/host0/bus0/target0/lun0: p1 p2 p3
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Uncompressing......done.
Freeing initrd memory: 134k freed
VFS: Mounted root (ext2 filesystem).
Mounted devfs on /dev
Journalled Block Device driver loaded
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Freeing unused kernel memory: 260k freed
Real Time Clock Driver v1.10e
EXT3 FS 2.4-0.9.17, 10 Jan 2002 on ide0(3,1), internal journal
Adding Swap: 72288k swap-space (priority -1)
MSDOS FS: IO charset iso8859-15
MSDOS FS: Using codepage 850
eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html
eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <saw a saw.sw.com.sg> and others
PCI: Found IRQ 11 for device 00:08.0
eth0: Intel Corp. 82557 [Ethernet Pro 100], 00:00:0E:B8:98:DF, I/O at 0xfcc0, IRQ 11.
  Receiver lock-up bug exists -- enabling work-around.
  Board assembly 000000-000, Physical connectors present: RJ45
  Primary interface chip i82555 PHY #1.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0x24c9f043).
  Receiver lock-up workaround activated.
8139too Fast Ethernet driver 0.9.24
PCI: Found IRQ 10 for device 00:12.0
eth1: RealTek RTL8139 Fast Ethernet at 0xccd4ac00, 00:a0:a2:00:ba:9a, IRQ 10
eth1:  Identified 8139 chip type 'RTL-8139C'
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 03:23:39 Mar 15 2002
usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 9 for device 00:07.2
usb-uhci.c: USB UHCI at I/O 0xfce0, IRQ 9
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
parport0: PC-style at 0x378 [PCSPP,TRISTATE,EPP]
ip_conntrack (1536 buckets, 12288 max)
eth0: 0 multicast blocks dropped.
eth1: Setting 100mbps full-duplex based on auto-negotiated partner ability 41e1.
ad1848/cs4248 codec driver Copyright (C) by Hannu Savolainen 1993-1996
ad1848: No ISAPnP cards found, trying standard ones...
CSLIP: code copyright 1989 Regents of the University of California
PPP generic driver version 2.4.1
Splash status on console 0 changed to off
SCSI subsystem driver Revision: 1.00
smb_get_length: recv error = 5
smb_request: result -5, setting invalid
smb_retry: successful, new pid=2481, generation=2
smb_get_length: recv error = 5
smb_request: result -5, setting invalid
smb_retry: caught signal
smb_retry: caught signal
smb_retry: successful, new pid=2481, generation=3
smb_request: tree ID invalid
smb_request: result -57, setting invalid
smb_close_socket: still catching keepalives!
smb_retry: successful, new pid=2481, generation=4

Ciao ciao e grazie